Catch it with three checks before anything goes to committee: count the tenancy rows in the document against the rows in the output, tie the roll to the T-12 and to the leases, and open the source page behind each figure the committee will read. Tools that cite the source document and page for every figure turn the third check into a lookup instead of a search.
Published by Titleman, which makes a rent roll reader and Underwriting. The checks apply to any tool. Updated 6 November 2026.
Why a transcription error is the one that survives
An AI reader that mis-reads a digit, skips a row or shifts a column still produces a clean table. Totals add up, formatting is tidy, and nothing looks wrong. The error is found only by comparing the output with something outside it, which is why the checks below all start from another document.
Check 1: count the rows
Count the tenancy rows in the rent roll on one page, then ask the tool how many rows it read. If the tool cannot state the number of rows in the document, you cannot tell whether its occupancy describes the building or the first page of it. Rolls with merged cells, floor groupings or a summary page ahead of the detail are where rows get dropped or shifted.
Check 2: tie the roll to the T-12 and the leases
The roll shows what is billed on paper; the operating statement shows what was collected. Compare annualized roll rent with the rental income line on the T-12 and explain the gap before you trust either. Then pull three or four leases, including the largest tenant, and compare rent, term and expiration with the roll. Our pages on reading a rent roll and T-12 for problems and on rent roll versus leases walk through the mismatches.
Check 3: open the source page behind each figure
Every figure in a committee memo should point to the document and page it came from. In Titleman Underwriting, each figure cites its source document and page, and where a figure could not be found the gap is named instead of filled. Occupancy, rent totals and WALT are calculated by fixed code from the transcribed rows, so the same rows give the same result, and they are withheld when the roll was not read whole. A reviewer can then spot-check the figures that move the answer, such as the largest rents and the nearest expirations, without re-keying the roll.
What "committee-ready pre-screen" means
It does not mean approved. It means a signer can question it line by line: each figure traces to a document and page, gaps are listed, and an analyst has done the roll-to-T-12-to-lease tie-out. Its job is to decide whether the deal earns more of the team's time. The investment committee memo standard lists what a signer needs on top.
Getting documents in
You can drop the deal documents, such as the rent roll, the T-12 or the offering memorandum, into Underwriting, or send a screenshot of a page. We have not measured how many transcription errors an analyst's manual check catches against ours, so we print no catch rate.
What this does not replace
- The analyst's tie-out. Citations speed the check; they do not decide whether the roll, T-12 and leases agree.
- Estoppels and lease audits. A lease on file is not proof of what the tenant says it owes.
- Site visit and legal review. Occupancy on paper is not occupancy on the ground.
- The committee's judgment. The bid and the go or no-go stay with your team.
FAQ
How do you catch a transcription error in an AI-extracted rent roll before committee? Count rows, tie the roll to the T-12 and leases, and open the source page behind each key figure.
What is a committee-ready pre-screen? One a signer can trace line by line, with gaps named and an analyst tie-out done. It is not an approval.
Can I drop documents or screenshots into Underwriting? Yes. Supply the rent roll, T-12 or offering memorandum, or a screenshot of a page, and each figure cites its source.
Does the analyst still check? Yes. See above.
Request a demo and run a roll you already know. More at titleman.ai.